2001 Dodge Neon "replace throttle body" Questions

...throttle body housing find your air filter and follow its assembly back to the throttle body this what your looking for the throttle is stuck by some build up in throttle body use some fuel injector ...

...from the backside of throttle body) to check for carbon bild up and possible faulty valve.Once removed if the little pintle is sticking out more than 1 in. then replace valve. Hope this will

...Check the fuel pressure,you need special equipment for this. If all else fails,you probably need a t.p.s.(throttle position sensor). Might need to replace the entire throttle body to get the

...replace the fuel pump but i dont want to if that is not the problem I dont think it would be the fuel pump, or else no fuel would to delivered to the engine. i would try cleaning the throttle body ...

...throttle body replaced the TPC cleaned and checked the IAC drained the trany pan, and replaced the trany filter ive looked at the linkage and the throttle cables and none of them cross one another or ...

throttle body and spray it out with carb cleaner. Also spray out the passages in the throttle body that the idle motor use. If that does not fix it you could have another problem like a bad idle motor

...throttle body clockwise to tighten the cable and increase the idle to 800 RPM. If the idle fluctuates, you may need to replace the IAC valve. However, your idle should hold steady if the valve's ...

...injectors, dirty throttle body, air filter, throttle position sensor, start with replacing and or cleaning these. I'd start with checking fuel pressure, in line guage if the car starts runs then ...

...throttle body that just needs to be cleaned.you don`t say if it will start after the initial stalling or if it will start with the throttle held slightly open.you could even have a bad throttle ...

...replace throttle position sensor on a 2002 dodge neon? I`m going to assume you know where the tps is, disconnect the wiring plug from the sensor, there are 2 screws(bolts) that hold the sensor to the ...