...the cables and wired attached to the transmission. The remove the bolts from the engine and drop it to the ground. Installation is reverse of removal. Is not a difficult job, is just time
removal. Before removing the transmission fluid pan, insure that the area is clean of dirt and debris 2. Place a large drain pan under the transmission. Loosen all of the pan attaching bolts to within
Transmission removal I am removing a transmission from a 94 for explorer 4x4 I just wanted to know what needed to be disconnected besides the bell housing, drive shafts wires and lines going to the ...
transmission removal pictures for a 1996 ford explorer..i need to know how many bolts there are to remove the transmission from the motor 4x4 has seven transmission-to-engine bolts 4x2 has six ...
...tranmision fluid on a 2004 ford exployer xlt. It has no dipstick to check level or to add fluid. On transmission pan drain plug will have a small hex screw in the center of drain plug, with engine ...
location of modulator The transmission modulator valve is located on the passenger side of the transmission near the top. It is accessible most easily by removing the passenger seat, (5 bolts), ...
...transmission. Loosen the retaining bolts on the oil pan with a socket wrench until they are within a few turns of removal. If the seal doesn't break on its own, gently tap it with a rubber hammer. ...
...vehicle needed this part and it is quite a job putting it in. any comments? between the motor and transmission... there is a gear on the outer edge of it that your starter drives to turn the motor. ...
I am removing a transmission from a 94 ford explorer and I was just wondering besides the bell housing bolts the drive shafts and lines and wires going to the transmission what else needs to be done ...
1,182 questions posted
Usually answered in minutes!
2,998 Questions
2,307 Questions
2,248 Questions
2,302 Questions
1,513 Questions