1997 Ford Ranger SuperCab "1991 truck clutch" Questions

...1991 Ford Ranger Clutch Problem. My 1991 Ford Ranger will not start. I am not sure if the clutch is shot or if there is air in the hydraulic line. I aslo don't know how to check either. Any ideas?? ...

...1991 Ford Ranger 3.0, 6 cyl w/manual transmission. When shifting it's not going into gear easily and some times not at all. Any suggestions? 1. Your clutch may be worn or out of adjustment. 2. If it ...

...clutch in a 1991 Ford ranger xlt I have a 1991 Ford Ranger xlt and I went to change the clutch in it..when I did I found out that the tranny is a 1997 and I can't seem to get the tranny back in and ...

...1991 ford ranger 2wd. im trying to replace the transmission and on the left side of the tranny theirs a cable or a tube of some sort, i cant get it off. their isent any bolts or clips to remove. any ...

91 ford ranger hydraulic clutch not working Most likely your slave cylinder has gone out on you, it is a common problem with Fords, it is located down under by the clutch some are inside the Bell ...

Stuck in 5th gear I have a 91 Ford Ranger ext cab. 2nd gear went out first then all gears went out. Sometimes clutch would fall to floor when pushed, but now clutch has good pressure. Cannot shift ...

1994 explorer sport 2 wheel drive 5 speed maual trans. This vehicle has about 150,000 on the original trans. I believe we are on the 3 clutch. It is starting to slipping slightly in 2nd and 3rd gears.

removing manual tranny 99 ranger a line going into the housing cannot get off That is the hydraulic clutch line going to the internal slave cylinder.You will need to get a "clutch line removal tool" ...

Brake line clutch slave The plastic sleeve on the brake line for the clutch slave cylinder is damaged.Is the plastic sleeve supposed to slide towards the tranny to release ? push in press release tabs

just installed a new clutch now it will not depress enough to shift into gear You need to take it back out - you have assembled it wrong. Are you sure you didn't put the clutch in backwards? If you ...