1985 Ford F 250 "460 timing cover removal" Questions

...460 engine. 1983 model and have to replace the front crank seal. how much trouble is it?I already have the radiator off and replacing it. You'll need to remove the crankshaft pulley and the harmonic ...

...460 7.5L that I am getting ready to replace the cam and lifters on due to knocking and I was wondering if anyone knows what all is needed to replace the cam and lifters? Yes you will need the ...

460 ENGINE . NEED DIAGRAM TO REMOVE FRONT TIMING COVER NEED DIAGRAM TO REMOVE FRONT TIMING COVER I do not have any diagrams but HERE are a good set of written instructions, this is an easy engine

...TIMING COVER. BEFORE REMOVING DISTRIBUTOR YOUR DISTRIBUTOR ROTOR SHOULD BE POINTING TO THE NUMBER ONE FIRING POSITION AND NUMBER ONE PISTON AT TOP DEAD CENTER. i have a 1996 f 250 with a 460, i ...

...460 engine that randomly missed at idle and under load, sometimes stalling at idle. After throwing hundreds of dollars in parts at it, discovered that the EEC-IV engine control module was the cause. ...

My ls460 has been standing for 2 weeks covered in ice and snow, when i came to start it, the battery was almost flat so i jump started it ( battery to battery). the car started but it is now showing 3

...460 easiest way to check if timing chain is broken? I have a 1977 ford f250 with a 460 and the motor wont turn over i was told its the timing chain whats the easiest way to check if the chain has ...

...460 engine.I have a new fuel pump pulling and returning fuel to a five gallon jug because the other two tanks will have to be removed and cleaned.I have replaced the spark plugs and installed rebuilt ...

...460 7.5 liter gas) timing chain cover gsk,do you need to remove oil pan? No, you can loosen a view of the oil pan bolts towards the front of the oil pan and drop it down a bit to get clearance to ...

...460- bored 20 over only thing reused was crank, it was polished and we used the distributer. Motor fires, lots of fuel, crank timing correct, good spark it will not run ...HELP remove all plugs and ...