1992 Ford F250 "460 ignition" Questions

...460 in a 38' RV. The previous owner left the ignition key on for a few days and burned up something. I've replaced the distributor (with pick-up module), the coil, the ignition module (on firewall), ...

...460. Put new ignition control module and new ignition coil but still only runs for about 7-10 minutes and shuts of. Gets no power to plug wires. 30 mins later starts right up. sounds like you have a ...

460 truck runs then will stall while driving then will start right back up it will do this as many 5 times a day and some days never at allchanged plugs and wires cap and rotor and ing coil you may be

1979 ford f250, 460 engine making noise like baseball cards in bike spokes, any ideas? bad fuel,spark plugs,or ignition timing

...someone please tell me what the ignition timing setting is for a 1989 Ford F250 w/460 cid engine 10 degrees btdc you need to check idle speed spec.look under the hood at emissions information

460 idles and loses spark and dies first look inside distributer cap for corrosion-clean or replace-no relief then inspect and test all ignition components--theyr old--make sure fuel pump is producin-

...460 starts and runs fine untill it gets warm then dies have changed inline fuel pump and plugs and wires and dis cap and fuel filter ignition moduel is heating up and seperating internally so just ...

460 in it. with ignition key on does the batt. indicator in the cluster lit?using a testlight(one side connected to ground), probe the wires at the connector of the alternator with ign. at on position

460 points out hei in I pulled the point type distibutor out of my 77 ford f250 and put in a 50k volt hei. What would be a good plug gap to run with the larger coil? I would run .044 to .052. The ...

...ignition switch off of the column and tried to start it by sliding the ign switch manually, still no results. switch was grounded when I tried it manually. out of ideas, please help! Truck is 1988 ...