...off of the alternator. A long handled ratchet works better. My Cavalier just turned 260,000 miles. I've replaced the belt twice and tensioner pulley once (bearings went out on it). Good luck! ...
...side cam pulley and the other two with their respective marks on the other pulleys. Install the tensioner, rotate the engine two or three times to make certain everything still lines up and your
Question about Pontiac Montana
...the tensioner pulley should have a 3/8" square drive hole in it to release the tension, I always start at the crankshaft and loop around leaving the tensioner for last, hope this helps, let me ...
...pulley and lower cover. Rotate crankshaft to TDC again and lock timing belt adjuster arm with a 6 mm timing cover bolt. Loosen adjuster nut 1 turn and ensure that belt tensioner freely moves. Push ...
...tensioner, idler pulley and both serp. belts. Noise does not seem to affect performance at all (good mpg, acceleration, etc.) but is very annoying (like a deisel motor). How much rotational play ...
Question about Isuzu Cars & Trucks
...tensioner pulley bracket pivot bolt was removed, tighten it to 31 ft. lbs. (42 Nm). Tighten the pusher bolts to 14 ft. lbs. (19 Nm). Remove the crankshaft pulley. Install the lower and upper timing ...
Question about Pontiac Montana
...pulley. 7) Pull out shroud, then fan, then fan clutch. Be very patient, lots of wiggling may be needed. 8) Locate belt tensioner on idler puller below the Power steering pump. Losen very little the ...
...pulley. 15. Drain coolant by removing the cylinder block drain plug and opening the radiator drain **** (Refer to MA section of the Service Manual). 16. Drain engine oil. 17. Remove intake manifold ...
728 questions posted
Usually answered in minutes!
830 Questions
613 Questions
518 Questions
483 Questions
361 Questions