...for replacing the #7 ignition coil detach electrical connector.remove hold down screw and lift coil off of plug,pretty simple job...just reverse the order to replace it, good luck ...
ignition coil one of the small wires should have power with the ignition on and the other wire should pulse when the engine is cranked over.if not the ignition system is not sending the correct signal
Question about Ford Thunderbird
...checked and found to be working. What codes do you have? Has the inginition starter switch been replaced, they recalled them and I think your car falls under the recall. This is the switch down
...it sounds like it could be in the ignition system itself. on my truck it was doing the same until i replaced the ignition ...
...ignition control module and coil did not help. There is no check engine light and there are no error codes set. Digging deeper I found that the PIP out signal reads a steady 6.5 volts when it running ...
...Replace ALL ---I said ALL of the COP Ignition Coils & problem solved (they only last 6 to 7 years) You can do that your self with a single 7mm socket The coils are avail from Rock Auto.Com I use ...
...coil and the ignition control module (loc. on the distributer) fuel pump comes on when key is turned and there is pressure out of the bleeder valve on the throttle body. still cant figr it out You'll ...
...rough start/idle seems like only a couple plugs are firing and there is no power. New rotor and dist. cap installed with no change. try to replace also plug wires specially the ignition coil ...
...2003 Ford Thunderbird How to replace ignition coils Bing ...
...ignition switch? maybe. Is there power at the coil with the key on? Take the connector off and use a test light to see if there is power at one of the connector terminals. please let me know if you ...
156 questions posted
Usually answered in minutes!
523 Questions
505 Questions
431 Questions
394 Questions
202 Questions