1999 Ford Taurus "valve chek" Questions

...a 3.0l 12 valve it had a misfire in three cylinders so i replaced the plugs it ran good for awhile then it started misfiring again and it had a code with multi misfire chek coil pack for weak ...

...chek temp at hses if there is large different in temp flash heater core again try back flash from both hoses You need to conferm that after the car has warmed up, that the antifreeze is flowing. The ...

...position up pointing up and step tree the marc in the upper it has to be pointing down check the valves in the first piston need to be close if you are no a mecanic is hard to doit this are the ...

chek, make sure thisheater valve is working, temp. on heater control in dash, cold to hot. The only real way of checking for warpage on any head is by using a bar that extends from corner to corner on

...started chek for a collapsed catalytic converter and/or a clogged exhaust system...if it only smokes when 1st started, it could need valve seals...chek for clogged charcoal canister too if

...valve not air mix dor chek. And other bad bad you have head gasket problem presser build and no water got heater coil only air. If no presser and start engin and hoses get fast hard not hot you have ...

...chek what is missing spark or fuel for no start,if u think fuel pump tap on gas tank lightly and have samone starting sametime Bleed the fuel system through the valve on the fuel rail. Depress the ...

my car shifts slow into o.d. what could be the problem (92 thunderturd 3.8) chek modulator valve at trany pull vacume hose and see if ther is trans fluid in hose if yes replace modulator valve

...valve from its assy an close it back. chek that is correctly closed. Dryve some miles and check the themperatur. if its ok than is problem with thermostat. If problem is not gone and car is ...

...is located that Valve? If i can fix it or replace it? the light of ANTI LOCK off automatically? its probly in the caliper. but chek 2 make sure that the ground wire is still ...