1995 Ford Aspire "put new tubes rear end" Questions

Ad

Question about Ford Aspire

1 Answer

...where the old seal was with some brake cleaner. replace seal with a new one or the gasket sealer in a tube spread evenly put cover back on fill back up with gear oil up to the hole in the rear ...

Ad

Question about Ford Aspire

2 Answers

...flash the old pipe one foot from front before fuel tank where old pipe still in good shape i put connector between old pipe and new pipe on back end i put regular universal tube fitting. works good

Ad

...new vehicle,never could When 3/16" steel brake tubing rusts out,you need to purchase tubing of different lengths, at the auto parts store. You cut,bend,and flair the ends yourself,fabricate so to ...

...new U joints on the rear driveshaft. Can that be the rear differential itself? (is the one that turns when you turn the front steering wheel too) Do you have the vehicle in 4 wheel drive? 4 wheel ...

Question about Ford Aspire

2 Answers

Put new pads on it to see if that would help but it has made it worse. remove the calipers and rotors. check your e-brake shoes inside the rotors. also check your axle seals, if they are leaking. make

Question about Ford Aspire

2 Answers

...new year!!!! right rear, left rear, right front, left front. (left hand drivers side) Generally you can bleed any system by following this method: Start at r/r wheel, then l/r, r/f l/f. Break each ...

...new screw type stainless Steel clamps. You have to take this one apart to put it on. Stick a 3/4 coupler into the other end and route a long section of 3/4 hose under alternator to the heater core ...

new one and note how it is installed. Verry easy. BEWARE! gas will run out of BOTH ends of the tubing as you remove it and out of the filter. They are directional. You have to put it in a certain way.

...new seal. pull the brakes off open the rear diff there will be a c lip holding the axle in, remove the c lip pull the axle repalce the seal on the end of the axle tube, put it all back together and ...

...put a side to dry (9) Attach tube to pump with a little loc-tight fill pump with oil pump lube (10)attach pump to engine block make sure rod goes in proper & bolt are tight. (11)Bolt pan back on ...

Not finding what you are looking for?
1995 Ford Aspire Logo

203 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1997 Ford Aspire
1997 Ford Aspire

113 Questions

1994 Ford Aspire
1994 Ford Aspire

85 Questions

1996 Ford Aspire
1996 Ford Aspire

76 Questions

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...