1995 Ford Aerostar "engine quits starts back" Questions

...back to no spark at coil. replaced coil. engine started up, ran for about thirty seconds and quit, restarted and ran for about ten seconds and quit. will not start again. no spark from coil. any ...

...back home. Check engine light on now. 1993 Cherokee, 160000 miles Sounds like the fuel pump is going out. Replace the filter first, as it's only $10. If that doesn't fix it, then it's probably the ...

ENGINE WILL QUIT AT IDOL OR WHILE DRIVING DOWN ROAD . WHILE DRIVING ALL THE LIGHTS WILL FLICKER AND SOMETIMES MOTOR QUITS . I SOMETIMES HAVE TO USE GAS TO START IT BACK UP . AT IDOL IT QUITS AND ALL ...

...quits wont start until engine has cooled I had the same problem with f-150. the timing chain would stretch when it heated up and cause it to quit and naturally it wouldnt start until the chain cooled ...

engine quits when driving engine quits running when driving. I have replaced ecm fuel pump and coil. didnt help Does it start back up ?  As with any no start issue you will have to figure out if ...

...start and once it's been running the engine quits. Starts back up after a couple of cranks than quits. Some times I can drive a 1/2mile or so than quits again. check the fuel psi u may have a

...your driveway, started driving down the street, no speedometer, and you just stayed in 1st as the engine RPM's got higher and higher ? Please explain what has happened. You should also have a check ...

...quits let sit starts and runs fine Does this have a "Check Engine" or "Service Engine Soon" light on? If so, get the codes pulled and post them back here along with the engine info. If no codes are ...

...engine on my 2000 MPV cuts out and dies when I press the accelerator. After it sits for an hour or so, I can travel for 20 min. or so before the problem starts again. HELP! I never had this problem ...

...engine for about 60 seconds. Then, the engine started back up on it's own and I was able to drive home. have the OBD codes read , sounds like fuel but the OBD will tell which sensor/switch is at ...