1987 Dodge Ramcharger "ignition coil" Questions

Ad

get fire to the coil but know thought the coil - ignition moudule/coil/ relay/ignition switch/resister/ has all be change llnsmith57@gmail where is the ignition sensor located on a 1985 dodge ram d150

Ad

Question about Dodge Ramcharger

1 Answer

coil ? any ideas ignition switch sends power to coil through several relays on my 1988 ramcharger the relays on the drivers fender send power to coil, distributor , and fuel pump use a test light with

Ad

...wiring. my bet would be on the ignition box though. Try running power directly to coil from battery see if OK then if so you have an ignition switch problem replace ignition switch in column good ...

...The primary (- & + terminals) usually run .4 to 2 ohms. The secondary (- & coil tower) usually run 6K to 15 K Ohms. Where can I find a ignition coil condenser for a 1985 Dodge D-150 pick

Question about Dodge Ramcharger

1 Answer

...coil-on-plug ignition system with no plug wires, remove one of the coils from the spark plug and insert an old spark plug, a spark plug tester or a screwdriver into the end of the coil. Ground the ...

no start condition no voltage to ignition coil location of auto shut down relay A.S.D in fuse box,also check your pick up coil, sit right under your distruibutor rotor unplug slide right out.Good luck

Question about Dodge Ramcharger

1 Answer

new plugs, wires, coil, ignition module, balist resister, pick up coil still no spark.1982 dodge ram charger Do you have a test light? Are you getting 12 volts to the Ballast Resistor.

Question about Dodge Ramcharger

1 Answer

coil, or in sequence if seperate ignition coils, hold the wire about a quarter inch from a metal part and have someone crank the engine. A bright blue spark should shoot from the wire to the metal. No

ignition coil with the key in the run position. if you dont have battery voltage at the coil run a jumper wire from the batterys positive side to the positive side of the coil and then try to start it

...ignition coil. During a start procedure, while the key is turned all the way in start position 12 volts bypass the resistor forcing a high output of coil voltage. When you release the key to the run ...

Not finding what you are looking for?
Cars & Trucks Logo

116 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...