1990 Dodge Dynasty "not run" Questions

...not stay running Have you tried taking a fuel sample? Next I would time the amount of running the engine does to see if it is consistent with a timer. Some vehicles have a startup circuit and then a ...

...and car runs for 2 days and when you go to start the car runs for 3 seconds what can cause that to happen Sounds like fuel pump relay is not switching from start to run. I recommend replace relay ...

It is not want to get gas to the engine to start If the fuel pump is not running, check the relay and fuse first.It only runs for a few seconds when you turn the key on, then the computer has to see ...

water on top of the motor underneat the plentem water runs driverside of motor and runs down on top of the trany I do not know for certain, but it sounds like your intake gasket may be going out.

radiator fan not running I have checked fuse, and relay, still not running Most fans plug into the wiring harness, plug could be corroded, also look for a ground wire with a rotted connection. Of ...

...but drops instantly to zero when ignition is turned off. When this happens, the engine will not start until I put 12 volts directly to the fuel pump. The pressure jumps to 40 and the car will ...

CAR WILL START, BUT WILL NOT KEEP RUNNING. Hello Sounds like you need a new MAP sensor if this does bad car will start but not stay running as you describe,,,,,, there is 2 screws that hold it on ...

...not run. I can not figure out how to reset the anti theft to see if this is the problem. Any suggestions ? Try locking and unlocking the driver's door with the key. It always helped me. This sounds ...

...as possible. Top off coolant if nesessary. This is a common problem with Chrysler products. Do not over tighten sensor, 5ft. lbs. Good

...if it;s charging, while the engine is running disconnect the positive side post of battery, careful not to ground it to anything metal, if car dies,no charge from altenator, if it stays ...