1995 Pontiac Bonneville "wiring new fuse panel 95" Questions

...- Short in a wire - Dash panel bulbs went out - Need a new headlight switch box? Please any help is much appreciated. Have you checked for power in and out of the dimmer switch for the dash lights

new neutral park switch on its still doing the same thing. I have even took it to the transmission shop the said the transmissions is fine, its something electrical. what is it???????? 95% of the time

...new battery installed in remote, all fuses good, still inop? 1. Locate the red two wired programming connector located near the central locking control module that is located behind LH Lower ...

...new injectors. fuel pump works. all fuses are good. and ecu is throwing no trouble codes.motor turns over but will not start Have you verified spark with calibrated tester? How many pounds of fuel ...

...new baterry I can not even get the vehicle to turn over, is the a specific fuse or some thing i may have fried ? any help would be appreciated Check fuse 26(10 amp) in the instrument panel fuse

...new one. it just clicks at the steering wheel Check the horn relay Horn relay located above the interior fuse junction panel. Hope this helps. Also check the ground wire to horn, if in doubt run a ...

...new one,but now der seems to be no power going to itrelays,fuses etc..all ok,tested fuel pump of batt an it workin fine.any suggestions?? you have 2 electrical plugs...only one wire should have ...

...wiring bought an change 3 way bulb holder. still same prob, don,t no were to go next Keith Somtimes the bulbs get a dead short in them even though they look OK. Install new bulbs or remove all bulbs ...

...new pump, filter and relay, get a voltmeter or agitator and test each of the wires, if your not getting power to it then its probably a hot wire coming from your battery terminal or one of the wiring ...

fuse, b.c the bulbs are brand new and the wires are fine. Can anyone tell me what fuse i would be looking for? thanks in advance... Your best approach to this problem is to buy a 12 volt tester. Looks