1989 GMC S-15 Jimmy "distributor" Questions

...running, and to set the ignition timing follow these procedures. There is a mark or notch on the distributor housing that the rotor should be pointing to when the engine is on TDC. (Top Dead

REMOVE DISTRIBUTOR FOR A 1996 GMC JIMMY Check this procedure... Disconnect the negative battery cable. If necessary, remove the air cleaner. Tag and remove the spark plug wires and the coil leads from

how to change a distributor Remove the wires and cap making note of which wires go where. Make a reference mark where the rotor is pointing on the intake. Usually a crayon or something similar is ...

...To Remove: Remove or disconnect the following: Spark plug wires and ignition coil wire from the distributor 4.3L Distributor CMP electrical connector Camshaft position (CMP) sensor harness ...

...on the crankshaft pulley to the marks on the driver side of the timing cover. Then install the distributor completely into the motor and make sure that the rotor lines up exactly with the "6" on ...

...turns over, coil will spark one time and we get no more fire. Have you checked to see if your distributor is aligned properly? I just had to change out a distributor on a 1997 GMC 3/4 ton that ...

1987 GMC Jimmy Distributor cap and Rotor replacement Is there a diagram that I should follow to replace the Distributor cap and rotor? If so where do I get one? A diagram may not be needed as its a ...

where are the rotor segment to align with the pointer cast in the distributor base? for a GMC Jimmy 2001 the mark you are looking for is a thin line on the top edge of the distributor body visable ...

MECHANIC STATING DISTRIBUTOR PLATE STRIPPED BUT STATING THAT ENTIRE DISTRIBUTOR NEEDS TO BE REPLACED AND ROTOR IN PIECES AND CANNOT BE BOLTED DOWN TO THE PLATE. HOW WILL I KNOW THIS IS CORRECT The OEM

...Top Dead Center (TDC) of cylinder number 1. Make sure it is on the compression stroke. Remove the distributor cap screws and cap to expose the rotor. Align the pre-drilled indent hole in the ...