1994 Mazda 626 "remove stuck drive shaft" Questions

...stuck will not come out with force. is there a specific technique to remove it Stick a large screwdriver or prybar between the CV housing and the transmission case, and pop it out. There is a little ...

...stuck open and must be replaced. The other way to test a thermostat is to remove it. * Suspend the thermostat completely submerged in a small container of water so it does not touch the bottom. * ...

...drive shaft Problem after removing shaft bearing shield seem to be stuck in steering knuckle . New c.v shaft comes with bearing shield . Question how do I install new shaft , with the bearing shield ...

...remove the drive-shaft so I can continue with the clutch removal and am currently stuck. Any help would be much appreciated. it takes a torque or star bit to remove the bolts i think its a t 25 or ...

just have to reuse the part that is stuck on the transmission and get a new clamp to re clamp the drive axle together. If you have any more questions feel free to ask and Ill do my best to answer them

...remove the alernator in my car, but I'm stuck on removing the right intermediate axle shaft. It's a 2003 Ford Escape. i can only guess it is a 3.0l 4v well as far as the axle goes, the rh outer half ...

...Remove the bolt(if any) to get slack in the brake line, release the plugs for the wheel sensor wires for slack. This way I can wrap my arm at the top of the spindle and pull it down, still having to ...

...remove the drive shaft from the transmission [or transfer case if you have a 4WD model]. Be sure to place a catch pan under this area, as fluid will leak out once the nose of the drive shaft is ...

...stuck to the housing until you break the seal from the gasket sealant Pull the axles out of the rear, remove the drive shaft and remove bolts on pumpkin. The whole unit pulls out with the carrier, ...

...stuck in low four wheel drive My jeep got accidentally put into low four wheel drive, and now I cant disengage, I tried to drive in reverse and shift it but that did not work. Put the transmission in ...