1991 Mazda Protege "put car drive died wont" Questions

put you're lights on its drawing a higher load on the battery and killing it. Does not sound like an "arc" of any type. I think you mean a short to power. That could be a possibility especially if you

put a new fuel pump in and filter. when it dies the cruise control light comes on I AM HAVING SAME PROBLEMALTHOUGH MY CRUISE LIGHT CAME ON BEFORE ROUTH IDLE AND THEN STOP RONNING AT AN IDLE WILL START

but the gas to the floor it sputters and starts to die the enigen light is on and the code is 22 so i put a new tps on and it still runs and drives put wont go faster then 55mpr Put on a mass air flow

...an hour to do a normal 15 minute drive, died and cooled about 5 times. ... Vehicle: 2003 Ford F150 ... It was cold when I put it on and after putting it on, started and drove for about 30 minutes

died while driving. It wont start now, turn the key and it just cranks, no catching. you need to put a scanner on it and see what code comes up. my guess would be the crank sensor which is very common

...car stay runing when it dies it wont start for about 15 to 20 minutes. when it does start it is not idoling right away it go from 500 r p m to 1500 rpm. if i git it going when i put it in drive and ...

...put it in drive then died I put my rodeo in drive and just stoped replaced the fuel filter and pressure regulator still wont start any ideas its have a bad idle too? verify sparks plugs, catalytic ...

...car but his battery died so i remove the battery from my mazda to charge his battery . after putting it back the car wont start at all no light on inside the car tottaly dead . but the headlight goes ...

...died and hasn't started since. I've put in a new coil pack, rotor, and distributer cap. I just put in a new distributer and it still wont start. Someone please help. If you have a coil pack on that ...

...died while driving.Then would only run for 30sec or less and die.Suspected the chip in the key put it into security mode.Had a new key made now truck wont start. ok check your timming belt then your ...