2004 GMC Canyon "blower motor resistor replacment" Questions

...blower motor resister,it is mounted right next to the blower motor,it has a lug with about 7 wires on it.Just unplug it and remove two screws to remove the resister.This controls the speeds for the ...

blower motor for interior fan only blows on high speed. All the lower settings dont work now The blower resistor pack needs to be replaced, it's common for the blower speed resistors to burn up and ...

blower motor resistor is bad it is under dash on passenger side There is a blower moter resistor on the back of the hvac box. All 4 blower speeds go through this resistor. orange/hi-lit blu/med-tan/lo

...blower motor resistor out. I assume that's what it is since these trucks have a big issue with it. Wen replacing the resistor I would recommend replacing the wiring harness for it as we'll since they ...

...but does work on 4/hi this is only the fan/blower. what causes this& how do I fix it? replace blower motor resistor located near blowermotor I have the same problem... how much was it to

...works on high air cond. only works on high ALL YOU NEED TO DO IS REPLACE THE BLOWER MOTOR SPEED DROPPING RESISTOR, IT IS NEXT TO THE BLOWER HELD INTO THE AIR DUCT WITH TWO SCREWS. PLEASE RATE

...blower motor 2004 GMC Canyon 2.8L 4 cyl w/5speed. the 3 lowest settings on AC/Heater blower motor does not work. It only works on the highest setting. The Canyon has an inherint problem with the Fan ...

...blower motor wire harness it was fried and the resistor was fried and nothing works now after every thing was installed any solutions to what I do next ??? Please help I'm in Arizona 115 today . The ...

...blower motor might b going bad bearings inside  mine did same but when replaced it got all speeds back Here are some more common problems. Motor: The wiper motor is commonly replaced and was ...

...blower only works on high is it the switch or resister That is usually caused by the resistor module for fan motor speed control. Replacement is quick and not very costly have the same problem wiggle ...