...break light are not working. i changes the bulb, but no go, only the lights come on. Hmmmm, I would check to see if connecting an individual earth wire would help here, remove the mounting screws and ...
...lamp failure I replaced all the light bulbs and tested them. All break lights come one when I hit the breaks, but the error message still comes on after I turn on the ignition. Same thing happened ...
break light keeps going off but the bulb is ok Hi there! Check the Earth / return wires for these lamps. Often just screwed to a piece of chassis. If there is corrosion on the connector, then you will
...with a 50 amp and still no luck!!!! check your connections to the relay, sounds like something is breaking down under load did you get the ballast (HID starters) with the HID bulbs ? I would say ...
Question about GMC Sonoma
...break where it enters the trunk (or boot) near the trunk lid hinge. Inspect the wiring bundle closely near the hinge for damage. Otherwise the park/neutral switch, on the front side of the ...
...lamp switch?? I have to believe that with all of the "non related" issues happening that there is a wiring harness problem. If you track the harness back from the tail lights you will probably find a ...
...lamp circuit. Finding the actual fault is important and not very difficult. However, a wiring diagram may be needed to prevent confusion. Looking at the typical warning light circuit, you'll see that ...
...lamp. The code number refers to a diagnostic chart in a service manual that must be followed to pinpoint the faulty component. On other applications, a special "scan tool" must be plugged into the ...
297 questions posted
Usually answered in minutes!
403 Questions
359 Questions
270 Questions
269 Questions
249 Questions