2000 Ford Econoline "focus dashboard lights working" Questions

...focus ZX3, #10 fuse keeps popping. My dashboard/speedometer lights and also the running lights on my 2001 ford focus ZX3 weren't working/lighting, so i replaced the #10 fuse. they came back on - for ...

...focus zx3 bulbs and fuses r good and my hazards work My blinkers brake lights and rear wiper all stop working randomly the lights on dashboard don't work but when I use hazards they work You need to ...

...Focus. Dashboard dead, no brake lights and blinkers. Car started fine no problem, after sitting a few minutes there was a clicking noise and my dashboard went crazy. Warning lights on my dash were ...

...Lights on. Oil light on dashboard when key turned. That means that your oil light is working correctly... that is actually your oil "pressure" light and if your engine is not running the sensor is ...

focus cruise control not working performed self test...ok when i press ON it dashboard light does not come on. However, when i press ON and RES the light comes on. checked both fuses Sounds like a bad

...focus Running lights (left side): Fuse #47 -- Running lights (right side): Fuse #48 -- Brake lights: Fuse #54. Fuse panel is on the lower left side (underneath) the dashboard. NOTE: If it is your ...

...Focus -Dashboard dials intermittantly working 2003 Ford Focus - intermittantly when the car is running all of the dials and milage readings dont work and the engine light in the bottom left corner is ...

...dashboard of my ford focus, wont go into gear its an automatic tow truck top the nearest ford garage ,its all electronic ,best buy is a focus diesel manual ,could just be stop light switch packed up ...

...focus (under the hood, underneath the steering wheel or down the side of dashboard at passenger side)It will tell you which fuse is for what on the under side of the fuse cover or in your instruction ...

...focus and the dashboard and running lights both don't work, I have checked the fuses and the bulbs(both are fine). What next? Could this be caused by a fried wire the switch itself. are you ...