...97 ford e-350 van Are you sure the temperature door is moving ? I have seen the door break or the actuator not move. It is either the door or the
1993 Ford Econoline E150, AC and Heat work, however I can't switch vents. All the air is shooting down at my feet. I noticed it look like air actuated switches. Is this true and could there be a hole ...
...your door panel and find the two-wire lead that goes to a connector that ends up at the door lock actuator. This is not that hard, generally 4 screws at most, lift up and it's off. Determine the ...
where is the heat door and actuator located 97 ford e-350 van behind the dash board
temperature Control Acuator location in a 1999 ford e150 van temp control actuator i heard was under the dash and you have to pull the dashboard out to replace it and takes about 5-6 hours to do it !
2003 Econoline door locks The door locks are pulsing but not enough to lock and unlock the doors Replace the door lock actuators
hesitates to start,tries to drain the battery.i changed the regulator and checked the alternator and its good. check the starter motor..... or the actuator in the starter..
...good coolant level good blend door suspect could be coolant temp. sensor may be blend door actuator motor, this van uses a motor to move the blend door from hot to cold, a good test is to
How do I disconnect the power to the power door locks ONLY to the CARGO side and rear doors so that only a key can be used to open them? You will have to pull the door panels and unplug the lock ...
...front New thermostat and flush still no heat Sounds like the heater control valve/ blend door. The actuator may be stuck or broken. The actuator opens and closes to adjust for the heat setting in
306 questions posted
Usually answered in minutes!
266 Questions
242 Questions
210 Questions
177 Questions
172 Questions