...problem which sound like a shift solenoid. If you take the care to a local garage or dealer you can have them scan the vehicle for the problem code, which will tell you which solenoid is
Question about Mazda 626
shift solenoids are used to tell the valve body when to change gears. If you have a bad solenoid, shorted wire to trans, or shorted wire from trans to pcm then the code will set. The shift solenoid is
Question about Mazda 626
...tell you that the shift solenoid is not working. Reattach the plug to the shift solenoid and pull the second plug attached to the solenoid. Perform the same procedures on this plug wire. Replace the ...
Question about Ford Cars & Trucks
...shift solenoid after replacing it on a 2000 Ford focus 2000 Ford focus no problem told at all, what caused you to act (DIY) TELL WHERE THIS SOLENOID RESIDES WE CAN'T SEE YOU HANDS YOU WENT INSIDE THE ...
Question about Mazda 626
tell you how to disengage the solenoid lock. It is under the shift console and can be accessed by removing the panel. You either have one of two problems. Either the solenoid itself is bad or you have
Question about Chevrolet Cars & Trucks
...http://etereman.com/blog/general-motors-transmission/how-to-diagnose-a-bad-solenoid-in-your-4l60e-transmission Shift Solenoid and Tests GM 4 3L 5 0L 5 7L How Can Tell If My 4L60 Transmission is ...
...shift solenoid. The 706 code is for the shift linkage itself. Telling the transmission is in park neutral, drive etc. This sounds like a problem in the wiring, check all connector plugs for corrosion ...
shift, the last one change until the speed is on 55mph. Shift solenoid. Hard to tell with one is bad because there is no way to really test them. However your may have 4 solenoids in your transmission
Question about Cars & Trucks
...shift solenoids and epc speed sensors. scan it or go broke fast. P7xx errors? P1710 too hot error tranny the PCM talks to the TCM in the tranny and the TCM does all the work, shifting and all that. ...
...shift solenoid. Oil burning is usually caused by bad valve guide seals or cylinder blow-by. Can you tell me what is the problem as the infomation you asked isent anything i can work with ie Shifts ...
822 questions posted
Usually answered in minutes!
410 Questions
356 Questions
269 Questions
277 Questions
227 Questions