...remove the 4 prong wire (may have to wait for entire unit before removing red lead?) and crossmember (only 4 bolts?) and/or then loosen 1 bolt then remove other-thenstand it up and turn around before ...
how do you change starter on 95 gmc sonoma? 4 cyl or 6> 4 cyl must remove the exhaust at manifold then the bar from engine to tranny then starter it is a tight squeeze
...to be able to remove the timing cover. You will also need to remove the intake and pushrods That is for a V-6, a 4 cylinder is much easier as you just need to remove the valve cover and the cam
code 304 won't clear new plug wirea,new coils 2002 4cyl sanoma Code 304 is a cylinder #4 misfire. After changing plugs did you clear your code by removing the negative battery terminal for a few ...
How long does it take to pull a drive shaft 1999 GMC sonoma want to tow without dolly. as long as it takes to remove 4 nuts but if u remove drive shaft the tranny will leak fluid
...remove the 4 nuts in water pump need to remove a large nut in front of the fan. on the back of the fan right in front of the pulley is your large nut.. grab the right sized wrench and hold the fan so ...
...4 wheel drive you must remove the differential carrier shield if equipped then remove the starter bolts and rotate the starter to get access to the wiring. Good Luck. I usually disconnect the battery ...
4 wire ties. You will need a special tool to remove the bolts from the existing ignition switch, (it looks like a reverse torx screw). To remove the other end of the existing Ignition switch cable you
...4 r 5 bolts under hood 1at bottom where door an fonder meet remove head lite(NOT ADJUSTMENT SCREWS) SHOULD B BOLTS B HIND LITE ON ...
...once the front cover( s) are removed You should see 2-4 7mm screws holding the radio assy to the dash. when you remove them the radio should pull out and you can unplug the wire harness and ...
359 questions posted
Usually answered in minutes!
403 Questions
359 Questions
270 Questions
269 Questions
249 Questions