2000 GMC Sonoma Extended Cab "crossmember removal" Questions

...like a special tool is needed. does transmission have to be lowered? I would say yes..the back crossmember needs lowered..and a special open wrench is used to remove the lines..fluid will bleed ...

...have to remove the 4 prong wire (may have to wait for entire unit before removing red lead?) and crossmember (only 4 bolts?) and/or then loosen 1 bolt then remove other-thenstand it up and turn ...

...crossmember. Lower transmission slightly to help gain access to the engine-to-trans bolts. Unbolt slave cylinder and hang it out of the way. Remove engine-to-transmission bolts, and bouncer bars (if ...

...removal.Remove the starter bolts and secure the starter out of the way, you can leave any wiring connected but don't let the starter hang on it's own wiring.     Your ...

...REMOVAL 1)Raise and support vehicle. 3)Remove the steering knuckle. Remove the bolts fastening the power steering cooler to the front suspension cradle crossmember reinforcement (Fig. 21). 5)Remove ...

transmission crossmember clearance? inline 6 to 327 in a 69 c-10 my inline had a 3 speed manual and my 327's got turbo 400.  I know i need to fab a rear support for the t-400 but do i need to ...

...nut, remove steering knuckle from the lower ball joint using tool KM 507 B. remove control arm to crossmember nut and bolt, remove rear crossmember to body bolt and remove control arm.torque

...Removal & Installation Disconnect the negative battery cable. CAUTION Do not remove the radiator cap or drain with the cooling system hot and under pressure or serious personal injury can occur ...

crossmember. Remove transmission cooler line-to-flywheel housing bracket. Remove brace rod to flywheel housi ng. Remove lower flywheel housing cover (if necessa ry). <0001> Remove starter bolts.

How do I replace a front suspension crossmember on a Chevy Silverado 2500 HD 4x4? The crossmember is about 2 feet long, it attaches to the front suspension on both ends. I need to replace a bent one. ...