1999 Pontiac Grand Am GT "crankshaft sensor prix" Questions

Ad

Question about Pontiac Grand Am

1 Answer

to replace your crankshaft position sensor located by the harmonic balacer. These sensors heat up and cut off the engine until the sensor cools down. This happens with age and it is not specific to GM

Ad

Crankshaft Position Sensor has gone out. They are pretty easy to change. You will have to remove your harmonic balancer/crank pully to get to it, as it is on the inside of the pully. Also, if you have

Ad

Question about Pontiac Grand Am

5 Answers

...a trac off light and service engine soon light on.Shut the vehicle off and would not start again.Found a crankshaft sensor was bad and a wire chaffed through by the AC accumulator.Total cost was ...

...grand prix with the 3800 series 3 motor? YOU HAVE TO REMOVE CRANKSHAFT HARMONIC BALANCER TO REPLACE CRANKSHAFT SENSOR.ITS LOCATED BEHIND IT.YOU NEED A HARMONIC BALANCER REMOVAL AND INSTALLER

Question about Pontiac Grand Am

1 Answer

...crankshaft position sensor. I have a 2001 Grand Prix, and when the crankshaft position sensor went out, the tach would drop to zero, and the car would act like it wanted to stall for about a

Question about Pontiac Grand Am

1 Answer

...crankshaft sensor on a 2003 ponitac grand prix gt After replacement of crankshaft position sensor, the computer needs to have the crankshaft position system variation learn procdeure performed. That ...

Question about Pontiac Grand Am

3 Answers

...crankshaft sensor location on my 1993 pontac grand prix 3.1 v6 front bottom of engine. It's wires connect to module and module is attached to coil packs. The Crankshaft Position Sensor is located: ...

...crankshaft sensor help..and where is it located, what tools are needed to do the crankshaft sensor uninstall and reinstall...are there special tool needed? No special tools are needed. However before ...

...crankshaft sensor to the block face and tighten the bolts to 14?28 ft. lbs. (20?40 Nm). Install the crankshaft position sensor shield. Verify that the electrical connector is secure. Install the ...

...crankshaft sensor located on a 1989 pontiac grand prix with a 2.8l v6 Will be on the side of the engine block.Held on with one bolt that screw into the block, remove bolt and sensor slide out. facing ...

Not finding what you are looking for?
1999 Pontiac Grand Am GT Logo

2,035 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Pontiac Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...