1994 Mercedes-Benz E-Class "type 4 camshaft sensor removal" Questions

...type ign.) Check your trigger circuit at the coil first. even if you have the mechanical timing wrong you should still have a trigger from the flywheel crank sensor. The camshaft sensor is used for ...

...4-Connector 6 pin5-Knock sensor 1 -G61-* Contacts gold plated Fitting location: Cylinder block intake side6-2-pin connector For knock sensor 1 -G61- Contacts gold plated Do not interchange7-Knock ...

...4. Inspect the spark plugs.INSTALLATION PROCEDURE1. Measure the spark plug gap on the spark plugs to be installed. Compare the measurementto the gap specifications. NOTE:• Use only the spark plugs ...

...4. Inspect the spark plugs.INSTALLATION PROCEDURE1. Measure the spark plug gap on the spark plugs to be installed. Compare the measurementto the gap specifications. NOTE:• Use only the spark plugs ...

...type. Professional maintenance is always recommended. Removing the Chain Cover 1 Disable the truck's ignition system by disconnecting the primary electrical connectors at the ignition coil pack. ...

type ignition system replace the distributor cap, rotor, ignition coil or ignition module from inside the distributor assembly. If it is distributor less ignition system then check the following items

...type of enines is the front one. Must remove the intake manifold. Fig. Right engine compartment view-4.8L, 5.3L, 6.0L and 6.2L engines (1) Ignition Coil 8 (2) Ignition Coil 6 (3) Ignition Coil 4 (4) ...

...type oil pump directly coupled to the crankshaft. Its pressure is regulated by a relief valve located in the timing chain case cover. The oil is pumped through an oil filter and feeds a main oil ...

...4 was 9.6 k ohms and 2-3 was 9.3 k ohms. checked coil towers all look good.!! PLEASE HELP ME!! CODE PO341 IS CAMSHAFT POSITION SENSOR SIGNAL RANGE PERFORMANCE CONDITIONS. CODE PO401 IS INSUFFICIENT ...

...4 bolts, then remove the crankshaft pulley. Remove timing belt front cover. Loosen the timing belt rear cover bolts as shown in the accompanying figure, then remove the camshaft angle sensor. end ...