2005 Pontiac Bonneville "remove plug control module" Questions

Ad

Question about Pontiac Bonneville

1 Answer

...plug the lines to avoid contamination. NOTE: One bolt located between the transaxle and the engine block is installed in the opposite direction. Remove the remaining lower transaxle-to-engine bolts ...

Ad

Question about Pontiac Bonneville

3 Answers

Do not have to remove any plug wires as to not mess up the firing order... Let the car sit for about 5 minutes and then use your secondary (in this case my wife's copy of the) ignition key. Vrrrooooom

Ad

Question about Pontiac Bonneville

1 Answer

remove the sound insulator panel beneath the instruments to access it Disconnect the plug The system is now disabled. That does not mean you can let your guard down. It means that you can now continue

...plug in the center. Unplug it and remove the screws. When you pull it out it should look like a series of small spring shaped coils. Most likely one or two of them will be burned up. Replace it in ...

...plug boots - Splits, cuts or breaks in the ignition wires and insulation. • Inspect all vacuum hoses for: - Correct routing. Refer to vehicle service manual, or Vehicle Emission Control Information ...

Question about Pontiac Bonneville

4 Answers

...Remove 3 inches of the orange sleeving from BOTH HALVES of the orange wire leads. Inside the orange you will find TWO WHITE WIRES, these are the wires that run from the micro chip in your key to the ...

Question about Pontiac Bonneville

1 Answer

...Remove the spark plug wires from ignition coils. Remove the screws securing coil assemblies to ignition control module. Disconnect coils from ignition control module. Installation Procedure Install ...

Question about Pontiac Bonneville

1 Answer

plug wires (2). Remove the ignition coils bolts (3). Remove the ignition coils and ICM assembly. Installation is the reverse of the removal procedure. 2.4L Engine Disconnect the negative battery cable

...Control Cable Removal & Installation To Remove: Before servicing the vehicle refer to the precautions at the beginning of this section. Remove or disconnect the following: The cable from the ...

Question about Pontiac Bonneville

1 Answer

...remove the tail light. There are 4 nuts holding in the taillight section and 2 phillips head screws holding the module in. The module on this side is 6 pin plug in. The one on the drivers side is a 5 ...

Not finding what you are looking for?
Cars & Trucks Logo

165 questions posted

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...