1998 Oldsmobile Cutlass "adjusting tensioner" Questions

98 cutlass serpentine belt too loose? we put it back on, buts it's too loose, is there an adjustment, or bolt to tighten? EITHER BELT TOO BIG OR YOU HAVE A BROKE BELT TENSIONER.WHICH HAS TO ...

brake adjustment actuator comes loose After replacing rear braked drums, which required reinstalling the brake adjustment star-screw and adjustment actuator, the actuator pops out of its hole in the ...

adjusting bolt which is located on the compressor tensioner bracket. Turn the bolt clockwise to tighten the belt and counterclockwise to loosen it. Air Pump To adjust the tension of the air pump drive

...1 click here for picture 2 Dont forget to unloosten the 15mm fulcrum bolt in addition to the two adjusting bolts or the bracket will not adjust. ...

tensioner. Any suggestions? What size of motor, do you have a/c and which belt are you replacing? Not sure about your engine size since you did not list it so please pick the applicable motor: Sebring

tensioner self-adjusting and is required to maintain constant belt tension. Fig. 5: Drive belt routing ? 1.9L engines 2.0L Engines The accessory drive belt for 2.0L engines has no provision for manual

adjusting bolt on the tensioner, tighten the belt to the desired tension. Tighten the fixing nut to hold the adjustment. Install the undercover and lower the vehicle to the floor. Connect the negative

how do you adjust the tension on 1995 cadillac deville serpentine belt? usually these are self tightening held with tension with a automatic tensioner if your car dosent have an auto tensioner then ...

...tensioner adjusting nut at equalizer to create slack in cables. Remove rear wheel/tire assemblies. Remove brake calipers and rotors. Verify park brakes are in good condition and operating properly. ...

...disconnect the negative battery cable or fan motor wiring harness connector before replacing or adjusting drive belts. The fan may come on, under certain circumstances, even though the ignition