1998 Oldsmobile Achieva "remove replace ac compressor 2" Questions

Remove that device and replace it with a piece of straight pipe. Locate your AC compressor. Disconnect the Wires to the Compressor so it can not activate when you select defrost. During the Winter you

...REMOVE MOISTURE OUT THE SYSTEM. YOU NEED AC TOOLS TO REPLACE AC COMPRESSOR.YOU NEED VACUUM PUMP, MANIFOLD GAUGE SET.YOU NEED AC LINES DISCONNECT TOOLS TO REMOVE ACCUMULATOR.YOU HAVE TO HOT WIRE AC ...

...remove the bolts holding the compressor to the cyl block fit new compressor replace the ac pipe orings Then refit the ac pipes reconnect ac clutch wiring refit belt. Then regas the system addind uv ...

...REPLACE ALL THE O -RINGS AT THE COMPRESSOR AND ACCUMULATOR AND THE LOWER CONDENSORS LINES WHEN REPLACING THE ORIFICE TUBE.USE NEEDLE NOSE PLIERS TO REMOVE THE ORIFICE TUBE.BESURE TO PLACE THE LONG ...

...Remove the blown AC fuse, connect a multimeter across the sockets for the fuse, measure DC voltage across the two sockets with the AC switch, and Ignition switch ON. Is Battery voltage present? Yes- ...

...replaced. ac compressor clutch coil open or short. wire cut or open to ac clutch.2 wires one is ground the other power, remove connector ac compressor then probe with test light between the two ...

...remove all air and moisture, also u will need to replace the accumulator/drier canister an the fixed orfice. always use new seals, never reuse old seals, if the AC has been contaminated flush it with ...

ac compressor cycle on off I remove a small amount of freon and compressor runs constant but does not cool fans run compressor runs I refilled system 2 weeks prior it worked fine but blew out low side

...replace the a/c compressor and enjoy the benefits of a/c during the hottest days of summer. 2. remove the a/c compressor and install a bypass pulley. option one gives the most benefit for the dollar ...

...replace it? 1. Make sure the vehicle is off with key removed. 2. You need to evacuate the refrigerant with a refrigerant recovery system. 3. Remove the ribbed belt. 4. Remove the noise insulation ...