1995 Oldsmobile Cutlass Ciera "red bolt brackets car" Questions

...serpentine or V-belt running over alternator pulley. Remove nut from back of alternator holding red cable and remove cable termination from post. Disconnect connector from alternator. Remove 2 or ...

...RED wire from the B terminal. Loosen the adjusting bolt, then remove the through bolt nut. Remove the alternator belt from the alternator pulley. Removing Alternator Remove the adjusting bolt, the ...

...red Loctite®272 to the threads of the bolt. Install or connect the following: Caliper mounting bracket bolts to the steering knuckle. Tighten the caliper guide pin bolts to 74 ft. lbs. (100 Nm) ...

...* Drive belt * Alternator B+ terminal nut and wire * Alternator field circuit wiring by pushing the red locking tab * Upper mounting bracket * Lower mounting bolts and the alternator To install: ...

...bolt, loosen only Alternator drive belt Alternator field circuit wiring connector, push the RED locking tab to release Battery positive terminal Upper and lower bolts, move alternator off pivot ...

...Red Locktite?: 350 ft. lbs. (After installing all frame mounting hardware) Track bar bracket: 120 ft. lbs. Front shocks: 111 ft. lbs. Draglink to small end of pitman arm: 85 ft. lbs. & reinstall ...

red). Sometimes it is held in place with a bolt sometimes it is clipped into the bracket. Remove either the bracket or the vent solenoid from the bracket. Unplug it. Remove the tube fro it. Replace it

...bolt. Don't over tighten the belt. It'll prematurely wear your bearings. Don't under tighten. It'll squeal. Do yourself a favor. When buying a New Alternator have them check it before taking it home? ...

...to jump start a2005 dodg viper positive from jumper car to to positive (red cable) on the Viper, negative from jumper car to metal ground on Viper, like a bracket on the engine or a bolt on the

...red x in them to see diagram images.5VZ-FE Engine Disconnect the crankshaft position sensor harness. Fig. 1: Exploded view of the crankshaft position sensor mounting Remove the bolt retaining the ...