1994 Oldsmobile Cutlass Supreme "foot lbs tighting head bolts" Questions

...Foot pounds (Final torque) Note: Torque sequence --------- | 6 2 3 7 | | 5 1 4 8 | --------- Step 1: torque in sequence to 33 Ft/Lbs Step 2: turn an additional 90 degrees Recheck final torque in ...

foot lbs. then going from the center again, this time in the opposing spiral, bring them down to 60 foot lbs. And lastly, bring them down to the specified tightness in your manual usually around 85-90

...know the correct order for tighting the bolts of head on my 1991 Nissan Pulsur 1800cc and the correct Toque CENTER OUT TORQUE 48 FOOT LBS 11 13 9 3 1 6 8 14 7 5 2 4 10 12 11& 12 TO 55-77 INCH ...

...not over tighten. torque spec 1.8L engine - 43-78 in-lbs 1.9L engine - 50-100 in-lbs 2.0L SPI engine - 71-97 in-lbs 2.0 Zetec engine - 54-70 in-lbs to convert from inch to foot pounds just divide by ...

...lbs Cannot answer that question. It likely relates to torquing a bolt. It implies that the bolt (or stud) is allowed to stretch a fixed amount during torquing tight. The process involves torquing the ...

...seal out instead. Axle torque is 175 foot lbs...don't back it off to get the pin through it, always tighten more. Hub bolts need to be tight but don't go crazy on them. 45-50 lbs is enough. Good ...

lbs...you need a solid breaker bar with about a five foot pipe added for leverage, or 3/4 impact gun. then remove wheel and caliper and rotor. Remove the hub bearing by taking out the three 12pt bolts

...lbs (varies upon size of axle nut...look it up or buy a bentley service manual), put the wheel back on and lower the car. The axle bolt is then tightened an additional 180 degrees with the wheel on ...

when tighting head bolts,long bolts 46 lbs and short bolts 43. is that foot pds or newton? That would be ft.lbs.

I have a 1987 Mitsubishi mighty max; how tight should the head bolts be? What should the torque be? 85 foot lbs start in center work your way out start at 45 ft lbs then 65 then 85