1992 Oldsmobile Achieva "pulley puller set" Questions

puller to the pulley and tighten the puller slowly to extract the pulley. Please let me know if you have questions, and thanks for using FixYa. Lock the flywheel: Attach the puller and tighten bolt to

...pulley make sure the puller purchased is compatable with your vehicle. You will have to rent a special puller to remove it and replace it. Caution do not put it on backwards or you'll bye another

...pulley puller set. You'll remove the crank bolt and then use the pulley puller to pull the crank pulley off of the crank shaft. The install the new pulley making sure to torque the crank pulley bolt ...

...set made for removing P/S pump pulleys. A normal 3 jaw puller will ruin the pulley. Once you get the belt off then you have to get the pulley off. Then you can acess the mounting bolts for the

...pulley puller. This is about the least expensive one that you will find: http://www.harborfreight.com/pulley-remover-and-installer-set-40749.html Be careful not the bend the pulley as they are ...

...puller / installer set so you don't have to buy one, and your local parts store may also have one available to rent. When you re - install the pulley, make sure you press the pulley on FULLY to ...

i need to pull the crank shaft pulley what do i use a gear puller? Its best to use a puller, you can borrow a set from autozone. Spray penetrating oil and let sit for 30 mins before using a puller!!

...puller can remove pulley. Most bearings are swedge fitted so the whole pulley needs to be replaced this comes in kit with a clutch coil also it is held on with a snap ring also. there are small ...

...Pulley lip- the Puller will snap the edge off! 4. Use a smaller sized Bolt inserted where the Crankshaft Bolt was, and use a set of washers small enough to fit on the bolt, but small enough to allow ...

...or a pulley/gear puller: http://www.harborfreight.com/automotive-pulley-puller-66868.html It's on the shaft pretty tight, even after the nut is