...tank and checked for power at the plug but did not have any power. I have tried resetting the computer and even rechecked all fuses and relays. Crank sensor and or cam sensor these control ...
Question about Dodge Durango
crank shaft sensor is bad. The sensor sends a signal to the computer about when to fire the coils for spark. Before replacing the crankshaft position sensor check the ASD relay in the under hood power
Question about Dodge Durango
...crank sensor is their anything else i do have a broken r ibbon ground rite by the sensor could this cause this some how First of all, even though I don't think it has anything to do with it, fix the ...
...crank but no spark. i have checked the cranshaft sensor (good), throttle position sensor (good), MAP sensor (good), even got another PCM and hooked it up. still would not start? It is not getting ...
...crank sensor or possibly the auto shutdown relay. use a test light to check for voltage at the coil. Hook the test light clip to ground and back probe the dark green/orange stripe wire at the coil ...
...power to the gas pump? Ok so there is residual pressure in the pump to give to crank but no run. Pump is your problem. The fuel pump has to prime the injectors ( residual pressure) and then continune ...
...power steering. Tried to crank but just kept spinning like it wasn't getting gas. Check for fuel pump when u turn on key it should prime for 5 seconds. Then it could aslo be a crank sensor or cam ...
crank, cam need to see if there is power same connector c1 #17 and connector c2 #31. if there isn't 5 volts at one of the two wires then you need to disconnect some of the sensors one at a time untill
893 questions posted
Usually answered in minutes!
2,049 Questions
1,616 Questions
1,378 Questions
886 Questions
1,005 Questions