2000 Mitsubishi Mirage "set timing 1" Questions

Ad

Question about Mitsubishi Mirage

1 Answer

...timing belt cover put jack under oil pan and raise the motor remove side engine bracket set a side remove top valve cover remove the spark plugs and turn the camshaft flywheel clockwise and bring # 1 ...

Ad

Question about Mitsubishi Mirage

3 Answers

...set. If your belt broke your camshaft timing is off now. To tell if your cam is timed or not you can remove the #1 spark plug and turn the engine over while you hold you thumb over the hole (2 person ...

Ad

Question about Mitsubishi Mirage

1 Answer

...1) on 3.0L California vehicles. DTC P0173 applies to fuel trim malfunction on left bank (bank 2) on 3.0L California vehicles. DTC Set Criteria (2.4L) Engine is in closed loop control. Intake air ...

1 mile. It was running a little rough but thought it was because I left it setting in a garage for a month. Then it died. So I started it back up and drove a few yards and it died again couldnt get it

Question about Mitsubishi Mirage

1 Answer

...1 and #2 plug wires (if accessible) off the plugs and just set them back in place without clipping back onto the plugs. Then, start the car, and gradually pull the wire(s) off the plug(s). The spark ...

...1 or 2 teeth out.Would a faulty oxygen sensor cause this?Tight tappets? Just trying to think outside the square a bit as the car runs ok but no power.I can't drive this in O/D and have to keep the ...

...set correctly on your plugs.  All platinum and iridium plugs come pre-gapped and should be inspected before you purchase them at the counter.  The gap specifications should be on the ...

...set in motion if the clock is in its normal timekeeping mode and not during setting operations. A. Push button (3) - 00:00 display appears; B. Push button (1) - stop watch is on; C. Push button (1) a ...

...1.Press "SET" for 3 seconds
2.Press "+" or "-" to select
3.Press "SET" to save
4.Repeat for Hours & Minutes

C-Daylight Saving Time
1.Press "Time" and "-"

D-12/24hr ...

Question about Mitsubishi Mirage

1 Answer

...set the timing and firing order? How to set my firing order for the timing do I have to set my first piston up Engine timing is done electronically. It is based on Cylinder 1 being a few degrees ...

Not finding what you are looking for?
2000 Mitsubishi Mirage Logo

324 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Mitsubishi Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...