2004 Mazda 6 "fit thermostate" Questions

...(may require a little prying with a screwdriver or similar tool). Note how the old thermostat is fitted (which end is up), lift it out of the engine, and then remove all traces of gasket from the ...

radiator over flow bottle fills with coolant. Had water pump fitted,then problem started.Changed thermostate ,no change.Cut centre out of thermostate,coolant no longer fill the overflow ...

thermostate installation installing new one. the new one pervents over heating engine is the seal supposed to fit the hole if so how? i have never seen a model of this vehicle ,but normally the seal ...

...(may require a little prying with a screwdriver or similar tool). Note how the old thermostat is fitted (which end is up), lift it out of the engine, and then remove all traces of gasket from the ...

...for the thermostate Follow the upper radiator hose to where it attaches to the engine to find the fitting. Unplug the temperature sensor, disconnect the hose and remove the two bolts that secure

...thermostate w/ a160 degree. 1: was that ok? 2:Stupid me-forgot to notice how it was removed so I could re-install same way......does the spring, go toward the engine or in the housing? Thank You very ...

thermostate for fan in front of radiator .how to fit you dont mention the year or modle??? the fan for the radiator is controled by a sensor(ECT)engine coolant temp. normally located around thermostst

temprature sensor where is the temprature sensor fitted on a 1969 Rolls Royce silver shadow. Its not on the thermostate housing. THERE ISN'T ONE

...pipe that connects the front exhaust manifold to the rear, the housing is behind that, its a tight fit,also if you follow the upper radiator hose from the radiator to engine the housing that the

where is the thermosted i need to replace it They ar normall under the housing on the cylinder haed that the top radiator hose fits on. However I have noticed lately that some manafactures are placing