2008 Hummer H3 "3 remove rear door" Questions

...there should be 3 boltz phillips screwdriver that you can see from outside . you wil have to remove door panel then there is connecting rods the part is about 50.00 used [email protected]. if ...

...3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY (a) Remove the screw. (b) Disengage the 7 clips. (c) Disconnect the connector and pull up on the rear door trim board sub-assembly to remove it. 4. REMOVE ...

remove 3 phillips/hex screws along the bottom inside of door panel 11. on outside/rear edge of panel push the 2 center pins of each in about 1/8"-this allows the clip to be pulled out w/ pin pushed in

...Remove latch assembly with actuator motor and door latch control rod lever link assembly. Installation Install new bushings and clip onto latch assembly. Install latch with links and power lock ...

Remove the 3 window regulator motor bracket nuts. Install the window regulator assembly. Tighten the 3 motor bracket nuts to 89 inch lbs. (10 Nm). Install the 2 window regulator nuts. Tighten the nuts

...Remove outside rear view mirror (17682) while guiding wiring and connector through hole in door. ItemPart NumberDescription 1 17682 Outside Rear View Mirror 2 N621906-S36 Nut (3 Req'd) 3 F8DB-17D699- ...

Remove door glass retaining clips and secure the window in the up position using masking tape or equivalent(FRONT DOOR GLASS CLIPS).3. Disconnect wire connector from power window motor, if equipped.4.

...3 and 4) Remove the outer door panel assembly. Refer to the sub-procedure under Door Locks, earlier in this section. For rear doors, loosen the bottom fastener of the rear door stationary window ...

...remove the entire cover or the little door thats atached to this cover on the passenger side? There are 3 brake lights that were recommended to replace. Driver side and passenger side plus the third ...

...3 bolts holding the top of the door panel on. Next remove the rear window console panel ( spring clips on the side towards the cab, tabs on the side towards the door ). Behind this should be a bolt. ...