Lens assembly The lens assembly has become loose. One of the outer rings has actually detatched from the camera body.When switching on - either the message 'lens fault' is displayed or a very blurred ...
my camera is olympus stylus 710.. the lens would come out and go back in. It says on the blue screen D : 5f08 5e02 There is a problem in the lens assembly circuit. Most probably the connector problem.
...has not been collapsed. Unfortunately in these little cameras everything is so tightly fitted and assembled that your best bet is to either replace the entire lens assembly or the camera itself. A ...
LENS ERROR,RESTART CAMERA Unfortunately this Canon SX100 (and the SX110 too) has a very fragile lens assembly. Once you have this lens error problem, there are only four solutions: 1) If it's under ...
Question about Canon IXUS Cameras
Problem during assembly in reverse order on Canon SD300 (Ixus40) Hi, Impossible to close the lens of my Canon digital camera SD300 (Ixus40). I followed the solution #3 posted on Apr 09, 2006 by Silly ...
When i turn on my camera, the lens goes in and out about 3 times, and finally turns on. when it finally turns on, it says turn off and turn back on immediately! i can look at pictures and videos, but ...
I have a Canon PowerShot S5IS, when I turn it on it saids, lens error restart, It still won't work. I spilled my coffee in my car and didn't relize that it got on the camera, When I saw it was
...assemble (control panel for flash & focus etc) and remove You will see that there are 3 srews that hold the hinge assembly together all 3 wiil be loose and require tightening (you will neeed to tilt ...
when i turn it on it says turn off and on again I have just had exactly the same thing on my daughter's NV3. In this case the lens cover would not open but if you power on the camera with you finger ...
112 questions posted
Usually answered in minutes!
163 Questions
129 Questions
57 Questions
28 Questions
25 Questions