Phoenix Gold Xenon-600.1 Car Audio Amplifier "amp power remote" Questions

...amp has no power the sony amp i got has no power running to it i cheched all the power wires and there good i also looked at all the fuses and there in perfect condition is there a power light on the ...

...power up my system, the t20001bd amp goes into protect. I checked voltage on batt pos. and neg.and is good. When I check the remote turn on at the amp it drops to 9volts dc. Also the speaker is fine. ...

...power source from the remote turn-on terminal of the amp to make it switch off. This is generally done by connecting the remote turn-on terminal to the head unit's power antenna or system control ...

amp power to the remote power on/off, the amp will come on fine so I know it is not a problem with the amp. I tested and found that I am just below 12v across the remote power wire, so I upgraded to a

power to the amp, REM terminal is connected to 12V, but led is not on and amp is off too. i didn't notice any burned up areas or power transistors nor visible damage on pcb. thank you for response You

...amp to a power source in the fuse box that turns on and off with the ignition. Some of the power sources you can find in your fuse box that go on and off with the ignition may be labeled something ...

...power thru the amp? I have the power connected, check with voltmeter, and checked fuse, power is there, amp wont turn on. The 'remote' terminal is powered by a lead that is normally connected off the ...

...Power going to the amp. Amp does not turn on. Do i need a remote? Bought vehicle with amp in it. Lxa 600 Power light does not turn on. ok remote does not mean the clicker to ur tv its the wire that ...

...that is powered by the remote lead has shorted open, allowing the amp to connect power and ground regardless of the remote signal. Should be a relatively inexpensive fix at an electronics repair

power to the amp but the indicator light does not turn on, I don't have the remote is that why the amp won't turn on? Yes, you will need to connect the remote wire to the remote output wire of the ...