ASUS WL-500g Premium Router "factory reset command prompt" Questions

...factory reset with a pin on the reset button, held it in for 12 secs, 30 secs neither performed a factory reset (I evaluated this by noting the unit did not reboot either while the pin was pushed in ...

...The configurations below are stored in ROMMON, and cannot be reset to Factory Default Settings by the write erase or config-register 0x2142 commands. warm-reboot memory-size iomem <not

...reset it to factory defaults by pressing the reset hole at the back. Press and hold it for 5 secs then wait until the LAN light turns solid and try to access again the router by it's default IP ...

...factory. When I moved we used to have a linksey system that worked great. Now we bought a netgear wireless router and we are having a problem with it connect to the internet. It shows that I have a ...

factory defaults by pressing holding the small button located on the back of the router, you can access the button with a small pin of sort where the button is very small. You will have to reconfigure

...the default gateway has been changed and cannot be altered, Would setting it back to factory defaults reset the gateway to? Cheers You should reset the router. or change setting by access the ...

...factory reset on the router, because something is very wrong! Let's see this when you're connected to the router. Start, Run, CMD to open a command prompt: Type the following command: IPCONFIG /ALL ...

...Address, you need to reset the router back to factory defaults by pressing the reset button at the back of the router for 30 seconds, unplug the power, wait for 30 seconds before you plug it back

...factory settings and setting up your wireless network again. There is usually a reset button on the back. Once the remote is reset, run "ipconfig" in the command prompt of your computer to find out ...

...reset the router to the factory settings. Once you have done this, do the following to set up the wireless network again: 1 In your "Start" menu, type "cmd" into the search or run field, and click ...