GE PDW7380NSS Stainless Steel Dishwasher "level" Questions

...is good and the glass filter is clean (Buyed new in june) make sure your dishwasher was installed level side to side and front to back check it with a torpeto level (that`s a small level about a ...

...off properly. how can thsi be tested? There is a float connected to a switch that controls water level. It is usually round and will move freely up and down by hand. But your problem might be a ...

...open circuit/short circuit or Thermistor or Safety T/Stat o/c or s/c or Element machine fills to Level Switch & Wash Pump runs. A03 = Thermistor open circuit /short circuit - machine drains until ...

UPPER LEVEL SPRAY DOES NOT SPIN - UPPER LEVEL NOT UPPER LEVEL SPRAY ARM DOES NOT SPIN - UPPER LEVEL DISHES NOT CLEAN plugged spray arm holes, pump intake partially blocked, too little water getting in

Dolphin Dishwasher, Why do they have a low water level sensor on the wash tank for, since the water level always over that level. This sensor is there to warn you in the event the water level is too ...

...so drawer doesn't slide out Top drawer keeps sliding out when front door opened You need to level your dishwasher - extend the front leveling legs, or shorten the back leveling legs (if your ...

...so the dishwasher can move freely as you adjust the feet. Check to see if the dishwasher is level side to side. Place a small level inside the dishwasher so it's sitting on the bottom pan and ...

how do you level a dishwasher Most units have screw jacks under the pads which wind down. As the units are normally under benches you need to adjust them a bit at a time to get it right. I would ...

...top draws slide closed on its own ,will not stay open model DD60DCX6 The dishwasher was not install level. You will have to level it. There are leveling screws one on each side at the front of the ...

I don't know how to adjust the salt level on Kenmore Elite 420 series water softener Hi, My Kenmore Elite water softner won't allow me to adjust salt level anymore. I filled up to level 7, then tried ...