Uniden BC370CRS Base Scanner "remove back 2 radio" Questions

...2 mm. off the connector and plugged the connector back. Still no display-just 12 vertical scan bars. [email protected] hello, Open the mobile and the refix all the connection inside maybe some ...

...remove the batteries,pull the power cord out of the scanner,push and hold the 2, 9 and hold buttons.While holding the buttons in, plug the power cord back into the scanner.This will reset the scanner ...

...remove all codes from my radioshack pro-76 scanner For a full reset, turn the scanner off and then power it back on while holding the 2 and 9 keys. CLEAr will appear on the display. NOTE: this will ...

...BACK! 2. REMOVE Backup battery cover "underneath" scanner! TAKE ALL 3 BATTERIES OUT. 3. I PUSHED THE POWER BUTTON TO BLEED ANYTHING OFF IN THE CAPACITORS, IF IT HAS ANY INSIDE? 4. PUSH THE"2", "9", ...

...Remove the battery for a hour. Put the battery back in. Press down at the same time and hold the #2 and #9 key when you switch it on - that will do a factory reset on almost all Uniden scanners. Then ...

...back to its terminal and the battery power will not reach the PC board. 2. The battery case (compartment) has 2 wires going from it (internal to the device) one black and one red. If either of these ...

...remove the paperclip off the reset button and wait for the display to turn back on.4. Now release the "TUNE/CLEAR" key.The scanner is no initialized and ready to be programmed again.Now program the ...

...remove the 2 solder from the can and you can see 3 coils dipped with wax, try moving the coil, tune to VHF or on NOAA channels then move the coil slightly. it should bring back the life of this ...

back as to what steps you took, results, etc, and I will try to assist you further as best I can. I am here at your service. P.S. - You can rate a solution with one of four ratings as explained under