Black & Decker GT300 Coffee Maker "fix spring amp" Questions

...fix?? First I'm not a OSTER tech. But I have worked on similar table top semi-automatic machines. You should call your vendor for service as there is no customer serviceable parts in this machine. ...

...spring and cut down until a light blowing into will allow water to pass but not too much so the backflow is compromised. Wow, thanks Terry! I had the same problem and did what you suggested and it ...

amp; since there are no clamps holding on the tubing, I used thin stainless wire double wrapped and snugged to ensure the tubing stays on this time. Note, there is wiring in the area. Make sure you do

spring and a rubber gromet. Remove all. 3. The thin stainless filter gets stuck over time to the machine body by a build-up of coffee grounds and oil, put a finger a small amount into the hole left by

...amp; Coffee Maker.When I turn on two group not heating up,I try wait about 15 minute but it reached temperature not yet,i checked every thing,however evrything is ok but gren light didn't come ...

SPRING AND BALL that is under the fitting, clean out tube and the hole that leads to the screen, that should clear up the problem. All fully automatic machines have a motorized system to move the brew

...amp; Decker Home Cafe GT300 won't stop untill water is gone My Home Cafe GT300 makes a loud noise during prime and brew and doesn't stop until all of the water is gone from the reservoir. I have ...

spring action "thing" should work automatically but if that system is not working then it will not work. -------- the hot steam droplets always remain in the thermo block which is later converted into