Hoover F7220900 SteamVac V2 Upright Vacuum "remove front cover" Questions

...remove the cord release, so that I can get to the two screws beneath it, so I can get to the cord reel. The front two screws are located under the front cover hinges. These screws can be accessed by ...

...front snaps free. Step 5. Carefully insert and twist screwdriver at each brush support to free brush from base. Step 6. Remove worn belt. Step 7. Slide brush supports off to check and clean brush ...

the motor cover of an Electrolux z4494 removed? Two screws at the front, accessed by opening the dust bag lid. Two screws at the rear accessed by prising off the on/off switch and rewind button covers

...front up. Lift back of powerhead cover and carefully remove. Look at light diffuser carefully and remember how it fits. Lift off the light diffuser. Push bulb in, twist, and remove. Insert new bulb, ...

...remove cover. Is there something else holding cover? The cover on the srew end will seperate but something appears to be holding cover on beater bar end. Pop out the two little rollers underneath, at ...

...remove the light cover. this can be done by pusing as you look at the front of the powerbrush on both the left and right side of the head. There you will find the lightbulb and 2 screws to remove. ...

remove the front cover on the vacuum in order to replace the wiring connected to the on and off switch? You will need a Torx bit or screwdriver with a torx head on it. That will remove the motor cover

remove 2 screws at the bottom front cover. This will allow the cover to be removed. Then remove 3 or 4 screws that hold the roller in place (from the top). you will be able to see the belt and replace

...Remove the accessory hose to expose 4 torx screws from behind that hold the front switch cover in place. After removing the screws, gently pull the front switch cover and carefully pry ...

...Remove the bag door from the front of the vacuum. Just above the bag door you will see two screws that hold on the front portion of the section that holds your tools. Remove the two screws and then ...