Roper RES7646KQ Electric Dryer "remove light switch side whirlpool" Questions

Ad

...light stays on replace that rectangular door switch.You may have a defective main control board. Unplug the dryer or turn off the breaker to the dryer. Double check to make sure dryer has no power. ...

Ad

Question about Roper Dryers

1 Answer

...light will not come on, I believe the problem is the switch on the door. The door switch assembly can be ordered from Roper, but I cannot find a schematic that shows me how to replace the switch. Can ...

Ad

...light or any response from dryer. check that the door switch is operational also there is a white fuse on the back of the unit on the left side after you remove the back panel it should have a closed ...

...light switch, which also runs the circuit to the motor is bad. To access the switch, remove the lint filter, remove the 2 screws under it, then with a screw driver, pry up the top lid, one side at a ...

light comes on but the power switch does not work whirlpool dryer was working, I opened up the door in mid cycle and closed the door and the power switch does not work now, there is power to the dryer

Question about Dryers

1 Answer

...light in the dryer burns out, remove it from the dryer. You may need to remove retaining screws and panels to access it. Replace the burned-out bulb with a new one of the same type and wattage; check ...

Question about Whirlpool Dryers

1 Answer

...light was staying on and no heat was given out to dry the load. I found it to be the float switch in the condenser unit at the back left. It had stuck with fluff and debris. I cleaned out the ...

...light? Good day, Pilot lights were last used in the 1970's. The gas valve is fired off by a silicone carbide igniter. There are many reasons for no heat. Here is a list. You need an ohm meter to ...

Question about Whirlpool Dryers

1 Answer

light going off when the door is closed, and on when opened??? sounds as if you having ansd issue withthe door switch, notthinkin the door is closed, try manually pushing the buton in, you should hear

Question about Whirlpool Dryers

1 Answer

...Remove the 3-4 screws that hold the lint duct assembly(metal blower cover) in place. CAREFULLY pull the cover away from the lint screen holder(be *darn* careful that you don't damage the wires ...

Not finding what you are looking for?
Roper RES7646KQ Electric Dryer Logo

217 questions posted

Ask a Question

Usually answered in minutes!

Top Roper Dryers Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

CJ Rock
CJ Rock

Level 3 Expert

4429 Answers

Are you a Roper Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...