can't open up my camera my lumix dmc-fz20 has jammed - I noticed a rattle. Following advice on this site I tried the tapping/banging thing but that did't work. I also replaced the battery to no ...
Question about Panasonic Lumix Cameras
...hands and patience to attempt this. If you are happy to proceed, do the following: 1. unscrew the screws holding the back of the case 2. lift the case carefully a bit making sure you don't break
...a little longer than the 10 minutes as another as written:) I had trouble getting 2 of the little screws out, but finally succeeded. Then I saw the orange ribbon, but nothing seemed to be loose. At ...
Question about Panasonic Lumix Cameras
...as well take it apart and see if I could figure out what was broken. After removing all of the screws and removing the top pin strip from the board (there is a piece of tape on it) and flipping ...
...and a fine paintbrush or blower.whilst the lens is facing down on flat surface...remove the four screws that hold the mount to the lens body.remove the electrical contact strip screws...you have
...and blow out all the sand and dust. To help you get it apart, take off all the obvious outside screws and then unhinge the back and front, with the hinge point being the top. The back and screen ...
...top section in place. do you know how it comes appart. To get the back off, remove the 4 visible screws on rear side of the cover. You'll then see that its attached at the flash holder. Don't try ...
...from ebay (there are still screens available) for £29 plus P&P. The screen was easy to fit undid 5 screws unclipped 2 ribbons changed screen reclipped ribbons and screws. and switched on camera ...
...to take off the lens so i can clean it. thanks GOT IT!!! I had the same problem. Took all of the screws out of the thing and disconnected the PCB. That allowed me to take the Lenses unit out. Once ...
...camera body, sides front and top are separated the LCD screen lifts up and there are a couple of screws that screwed directly into the back of the sensor mounting bracket area once these screws
239 questions posted
Usually answered in minutes!
630 Questions
338 Questions
296 Questions
256 Questions
202 Questions