1999 Peugeot 406 "ohmmeter" Questions

Have you looked at the fuse box cover for details? You can test fuses in place with a test light or ohmmeter to see if any are bad. Go to http://www.peugeotlogic.com/ Then look on the left side of the

...to Test 38. If there are no damaged terminals, proceed to step 4. With sensor disconnected, connect ohmmeter between 60-way connector terminal No. 67 and ground. If ohmmeter shows continuity, proceed ...

...COIL (HEI) 1. Isolate 2 pick-up coil lead wires. Remove pick-up coil connector from module. Connect ohmmeter to either terminal and ground. See Fig. 4 . Connect pump and apply vacuum to test vacuum ...

...power steering pressure switch on a 93 caddy deville.My Haynes repair manual tells me to connect an ohmmeter to the terminals on the switch body,start engine,turn wheel and read the ohmmeter... ...

...Engines See Figure 1 Tag and disconnect the distributor lead and wiring from the coil. Connect an ohmmeter as shown in Step 1 of the accompanying illustration. Place the ohmmeter on the high scale. ...

...is still on sounds more like a relay problem but could be a switch. The relay can be tested with an ohmmeter and the swith with voltmeter and ...

...wires, dist. cap, and rotor are good, check the coil. Take off the negative battery cable. Use an ohmmeter and check resistance between the coil primary positive terminal and the frame of the ...

...be on one side of the airhorn. If you disconnect the electric connection to this part and use an Ohmmeter, insert the leads into the part and move the throttle. Engine off, Key off. If the

...then it may be a poor or faulty wiring connection, relay, or fuse. You can test with volmeter/ohmmeter or even better yet, use multi-tester and test for 12 volts in wiring and use ohmmeter for ...

...the butterfly plate in the air induction system. Disconnect the connector to this part and hook an Ohmmeter to the TPS unit. Then open and close the throttle by hand and observe the Ohmmeter action. ...