...TV uses small voltage regulators. On each side of the regulators is the input voltage and the regulated output voltage on the other side. There are capacitors used for stabilization on the input and ...
...at the input of the yoke transformer. Use the schematic to find the value of the capacitor that has malfunctioned. I hope this helps, Thank you, Shuttle83 ...
...input. I was told perhaps this is a voltage ripple problem; I replaced a bad capacitor already and it helped ever-so-slightly. Strangely, the Closed Captioning shows up fine on top of the distorted ...
...input is the same. I have ruled out the digital board. Hi Thanks for using FixYa. The fault protection circuit has detected a fault and has turned the TV off. You'll need to check various things to ...
Question about Toshiba Televison & Video
Mitsubishi WD-62525 bglod fixed, but inputs are broken Mitsubishi WD-62525 I had the bglod for over two years until this morning when i replaced the bad capacitors. my tv finally come on, however it ...
Rolling Picture on all inputs -- PIP? With some help, I replaced 4 capicators on the DM board. For a while, it was back to working normally again. Now I get a rolling picture on all inputs and suspect
...fine and everything, but I can't seem to find out how to change the channel to the component or VGA inputs, when I push the device button the only options I get are Antenna (tv), Cable (rf), VCR ...
Input). Could this be a capacitor problem? I seem to be reading a lot about it here, if so where can i get instructions on replacement. I do not have a problem taking the TV apart and soldering. If it
Question about Philips Televison & Video
tv turns on and off all by itself, all day long. picture is still perfect when it stays on long enough. I unhooked everything from back and only used av2 input and it worked for 2 days perfect. but ...
Question about Toshiba Televison & Video
...input source on TV and a continuous message "check source cable" appears on screen whether in SAT mode, DVD mode, or any other. Sounds like you have a defetive main pcb. You might try a ...
507 questions posted
Usually answered in minutes!
364 Questions
299 Questions
263 Questions
243 Questions
264 Questions