replace rotters how to replace rotters on front Remove tires and wheels. Place car on stands. . Remove bolts from calapers and place aside. Remove outer wheel bearing. Slide rotor off of axle. Remove ...
Question about Replacement Tie Rod End Vehicle Parts & Accessories
the tie end rod will not budge. all nuts and cotter keys removed, supposed to be able to lift it out, but it is not budging. We have pried, tapped to no avail You need what is call a pickling fork to ...
Question about Chevrolet Vehicle Parts & Accessories
my passenger electric window wont go up using the passenger door switch. the drivers controls operate it correctly. do i have to remove the door panel to change the switch? I have a chevrolet spark ...
Question about Dodge Vehicle Parts & Accessories
Need to swap out 2 pin motor for a 6 pin motor I already have a new regulator/motor attached to the inner panel, which I purchased. The problem is they gave me a 2pin motor and I need a 6pin. I have ...
Question about Vehicle Parts & Accessories
how do you remove top balljoint from arm on a 2001 renault master? I assume you mean the steering arm outer balljoint. 1. Break the locknut free which meets the inner part of the balljoint, but don't ...
Question about Vehicle Parts & Accessories
how to change the output shaft seal in 96 honda accord Remove c/v shaft after you get the axle nut off pry drive shaft out of trans axle . ( I assume this is where the leak is) use a small part bar to
Question about Replacement Vehicle Parts & Accessories
how to change a corner light assembly 2001 mitsubishi Remove inner fender and get it from the inside.
Question about Mercedes-Benz Vehicle Parts & Accessories
fuel filter location on mercedes ml55 You will need to remove the left/rear wheel. It is located in near the inner frame rail area about 8 inches forward of the wheel. -Remove the inner fender liner.
Question about Access Vehicle Parts & Accessories
Antenna was broken off right @ the base....how do I replace the antenna? It is a 2002 Ford Explorer Limited Edition My base is a soft rubber compound and then the hard plastic base projects through ...
1 questions posted
Usually answered in minutes!
1 Questions