KitchenAid Architect® KUDT03FT 24 in Builtin Dishwasher "washer replace control" Questions

washer: Control Panel Problem I have a KitchenAid dish washer that suddenly the front control panel just stops working. I checked the power, checked the connection.. everything seemed ok. Any help ???

...washer has reached this cycle, if voltage exists and pump is not responding then the pump is defective. If no voltage exists then its likely that the control board located within the door has failed ...

I replaced the control board but the washer still will not start. Does the start bottom on the front need replacement? replaced the front control panel

washer control panel normal cycle light blinking, not responding Dishwasher Normal cycle light blinking, constantly. No pauses, no other lights on the control panel will turn on. Not responding at all

...washer FDB4315LFo Error code uo Fills then error code UO flashes You are experiencing a vent issue - While in wash cycle, Main Control Board does not receive signal from vent assembly that vent ...

...leak. If there is no water under the washer, you probably have a faulty float switch or possible a faulty control module. Hope this helps. Post back if you need further assistance. Regards, ...

...washer wont turn on and i have checked the breakers and i dont know what else to do. Its only 2 years old Make sure there's power getting to the dishwasher. Check for a tripped circuit breaker or a ...

...control panel by push a combination of hi temp and heated dry and the washer started working. However, after a minute of jumping around to different cycles the washer stopped and now all lights are ...

...washer's still functional when I hold the button pushed. Could it be the button mechanics that broke? If yes, what part do I need to replace? In another power light related solution earlier, you said ...

...control panel PN 99003139, THREE times. Each time same thing happens. The lights and buttons gradually and intermittently go out. The dish washer will still run, so long as the st art button is still ...