Kenwood KM300 Chef Stand Mixer "speed control fix" Questions

Speed control adjustment is loose on one side and when it moves away from mixer the motor speeds way up. If I hold it in place the speed adjusts normally. How can I fix it? I cannot aford repair shops

...speed control plate screws,there are 3 screws on this plate, one at the bottom two at the top, see if adjusting the top screws slows your mixer down. Next check the wiring of the mixer, Insure ...

...a near new Kambrook Powermix. Tonight the knob that controls beater speed broke and speed is stuck on high. How can I fix this? Obvious answer I'm sure, but you'll have to replace the speed ...

...speed control board, easy fix about $35.00 for the part and an hour of your time, not even messy to do a total of six screws and four wire connections that clip on, several youtube step by step ...

...speed control not working. Accelerates and drops speed itself. Have so far new PCB ordered changed and nothing happened. The system have only two electrical parts the electrical module and speed ...

speed control board (black and copper plate) and the phase control board. i bet it fixes the problem as these are the two parts that regulate the electricity in the mixer. Hope that helps. Buy the way

...speed control lever mechanism as you move it from off to the highest speed watching for binding etc. If the governor appears to be opening and closing as the speed increases and the linkage is not ...

Speed control 1-10 speed, lowest and 9 & 10 don't work, is there a way to fix this? You need to either clean the contacts on the control board, or replace it. Parts are available online or use Google ...

...speed control plate, Remove the trim and end cover on the mixer, the first thing you should see is the speed control plate, this has 3 screws on it, try adjusting the top two screws 1/4 turn, this ...

...speed control on my 901a sticks out and freely spins, I have to push it in to turn the machine off/on and control the speed. Can this be easily fixed by a novice (me)? my mixer is going only at full ...