Ryobi Factory-Reconditioned 30cc 18" Gas Hedge Trimmer ZRRY30550 "screws carb hedge trimmer" Questions

...screws in on side of carb and then back them both out 1 1/2 turns. This is called the initial adjustment and you can fine tune it from there if needed, but only turn the screws about 1/8 of a turn at ...

Trimmer Replaced primer bulb, Starts OK but, will not keep running. Try adjusting the low side screw on the carb. Back it out about 1/8 of a turn at a time until engine continues to idle. If this this

...carb to its standard settings, screw both tuning screws right in ant then turn anticlockwise to the following settings H 3/4 of a turn. L 1 full turn. This should set it back to standard. If this ...

...screws ? there are mntwo different size fuel lines which one does the gas filter hook up to? you shouldnt have too - remove carb disassemble an flush with carb cleaner - might as well but new ...

...carb need adjusting? Help! yes the throttle isnt giving enough gas. there should be two screws side by side somewere near the trigger next to the cable that moves when you pull the trigger. play ...

I need someone to tell me where to start when adjusting the carb. steps in adjusting a carb 1 take off the air filter case you'r carb will be under it 2 move choke lever to full choke the float should

...adjustment problem,2 small screws and a larger one possibly throttle control Standard carb settings are, screw both the H&L screws in, then turn them BOTH out anticlockwise 2 & 1/4

...screws on the carb, one is for adjustment the mix at idle and the other under throttle conditions. You can tune the engine by ear. Refer to your manual for which screw is which. If you don't have ...

TrimmerPlus 720r Manual Mine would start and run on the primer gas then die. Replaced the plugged fuel screen under the flapper valves on the single large screw cover of the carb. Runs well now

...trimmer w/a walbro carb. #wyj 192 805. The plastic throttle part that fits into the body of the carb. will not screw down tight on the body. Does it have a gasktet or oring between the body of the ...